I don’t know if you have encountered such a situation. The track lights are installed on the ceiling of the aluminum square pass, but since the lights are all facing one side, the center of gravity shifts after the loading and the whole track is turned over. The previous work has been done… …

gartenmöbel design
bettwäsche tom und jerry
planeta sport muske patike novi pazar
giorgio armani sport
adidas beckenbauer trening
bomber jakke burgunder
гуми 18 цола
esprit round sunglasses
liemenes mergaitems
windows wont connect to iphone usb

What I want to share with you today is some tips on how to solve this problem.

Start with a question from a student.

In the study group of the Wuhan class, a student sent a picture like this:

Q: If all the lights are on one side, the rails will roll over. How should this problem be solved?

Before solving the problem of lamp rollover, let’s first understand the structure of the underside aluminum ceiling, so that it is better to prescribe the right medicine.

Understanding aluminum square ceiling

Let me show you the real thing first:

In general, in the case of only one lamp, the rails will not roll over. However, if you install a few lights and then turn the lights off, the rails will be taken off like the picture below.

For example, in the large classroom of Yunzhiguang Guangzhou, the three spotlights on the guide rails are all facing one side and they are smashed.

How to solve it?

Solution

Method 1: Find a heavier light to the other side, act as a counterweight to pick it up and balance the center of gravity.

Of course, this kind of extensive solution is only suitable for use in private spaces or places where the aesthetics are not demanding. In commercial shops, this can not be done. After all, the other side does not necessarily need light, and this is not beautiful enough.

Method 2: Lifting on both sides with a hard screw

After consulting a factory that specializes in rails, they gave the answer, choosing a hard screw and using a hard lifting. The screw rod is not directly hung on the center point of the middle of the rail but is stuck on both sides of the rail through a card slot.

So, the designer friends who have encountered this problem in the future know what to do? Go to the factory for the guide rail lights and ask if they have such accessories.

Problem extension

At the same time, Tao Binshou also expressed his opinion on this issue.

He believes that the installation of the track outside the ceiling is completely ruined by the design of the aluminum side ceiling.

Tao teacher hand-painted a hand-painted scheme. He suggested that the track should be received within the height of the aluminum square pass, and then nailed to the secondary keel through the screw so that it would certainly not roll over.

According to Tao’s painting method, the track should be mounted on the side of the square pass. The bottom of the track is touched by the auxiliary keel. In this place, the four-bar screw is used to stabilize the place and the track is directly nailed to the keel.

At the same time, the tracking box is also received inside, revealing a little lamp, so that it is in line with the beauty of this ceiling.

In fact, this kind of ceiling light is not particularly suitable. It is better to use the square grille spotlight, which is just between the two squares.

Also nailed to the bottom keel, and then use the grille spotlight to adjust the angle of the light, which is more suitable for aluminum square ceilings.